The Classic Kit

Hardware kit for a single sliding wood door

This kit does not include a rail.
This kit will work with any one of the three lengths of rail which are sold separately.
The end of each rail is pre-drilled to allow for interconnection with other rails or the installation of the soft close. (sold separately)

Product number



Requires ONE of the following products

Flat Bar Track/Rail, Wall Mount Matte Black Product no. 24600290
  • Rail Length: 2.5 m
  • Number of Doors: 2 / 1
Flat Bar Track/Rail, Wall Mount Matte Black Product no. 24600390
  • Rail Length: 3 m
  • Number of Doors: 2 / 1


Product number 24600690
Finish/ Color Black
Type of Door Wood
Door Thickness 1 3/8 to 1 3/4 in
Weight Capacity per Door 15 to 80 kg
Soft-Close Mechanism Available, Sold Separately
Soft-Close Type Both Ends Operation
Rail Length 2 to 3 m
Door Position In Front of Wall
Track Mounting Wall Front Using Brackets
Design Intent Closet & Walk-In Closet, Pantry, Storage, Standard Access Door
Door Mounting Method Screw
Roller Position Upper
Door Width 24 to 60 in
Rail Type Flat Bar
Number of Doors 1
Roller Type Ball Bearing
Groove Needed for Guiding System Yes
Groove Width at the Bottom of Door 7 mm
Groove Depth 20 mm
Material Steel
Our Divisions Onward
Operation Single Sliding


The rails are available in three different lengths allowing you to install two doors side-to-side. Rails are pre-drilled to allow you to connect them end-to-end using the connector kit and to allow installation of end-rail bumpers.

Security: Each roller is equipped with a device that prevents derailment when the door is being misused.


- 2 roller units with screws for 1-3/8" or 1-3/4" door
- 2 end bumpers with screws
- 2 anti-derailer units with screws
- 1 floor-level guide for wood door.


Note: Picture for visual reference only. Actual product may vary from that shown in photo. Be sure to order hardware before beginning fabrication or installation work. It is preferable to use instructions inside the manufacturer-provided packaging.

Manufacturer reserves the right modify the product and information relating to that product without prior notice. All technical drawings and documents contain examples for the assembly of different supplier hardware. Customer cannot derive any claims from the use of these documents. No responsibility is assumed for design details relating to the construction or project.

Job execution or installation must be done by qualified persons. Ensure that product is correctly installed and anchored using anchors that are appropriate to the material. Never exceed manufacturer-recommended dimensions or weight. Never use an aerosol lubricant on this product. Always use a soft dry cloth to remove dust, debris and wood or aluminum filings from the rail before installing the rollers.


Disclaimer: The above information and our technical advice on the implementation given in writing, verbally or in the form of tests is for information purposes only and is not contractual. This advice does not relieve you of the responsibility to verify the accuracy of the data and the applicability of products for the intended purpose. The application, use and processing of our products and the realization of your projects under our technical recommendations are beyond our control and are therefore entirely your own responsibility. The manufacturer reserves the right to modify the product and information relating to that product without prior notice. The sale of our products is subject to our Terms of Sale. Please note that Richelieu will refuse any return or claim for a non-packaged product.
The Classic Kit

Product number: 24600690