The Classic Kit - 246015170
Hardware kit for a single sliding door
This kit does not include a rail.
This kit will work with any one of the three lengths of rail which are sold separately.
The end of each rail is pre-drilled to allow for interconnection with other rails or the installation of soft close (sold separately).
|Finish/ Color||Stainless Steel|
|Type of Door||Wood|
|Door Thickness||1 3/8 to 1 3/4 in|
|Weight Capacity per Door||15 to 80 kg|
|Soft-Close Mechanism||Available, Sold Separately|
|Soft-Close Type||Both Ends Operation|
|Rail Length||2 to 3 m|
|Door Position||In Front of Wall|
|Track Mounting||Wall Front Using Brackets|
|Design Intent||Closet & Walk-In Closet, Standard Access Door|
|Door Mounting Method||Screw|
|Door Width||24 to 60 in|
|Rail Type||Flat Bar|
|Number of Doors||1|
|Roller Type||Ball Bearing|
|Groove Needed for Guiding System||Yes|
|Groove Width at the Bottom of Door||7 mm|
|Groove Depth||20 mm|
- 2 roller units with screws for 1-3/8" or 1-3/4" door
- 2 end-bumpers with screws
- 2 anti-derailer units with screws
- 1 floor-level door guide with screws
The preceding information as well as any technical recommendation given in writing, verbally or based on tests is provided to the best of our knowledge.
However they are non-binding recommendations only, and do not affect your responsibility to determine the correctness of given recommendations and suitability of the product for your particular purposes.
The application, use or processing of our products as well as the production of products based on our technical recommendations are beyond our control and therefore fall exclusively in your area of responsibility.
Sales of our products are subject to our most recent General Sales and Delivery Conditions.
Please note that Richelieu will not accept any returns or claims for unpackaged products.
Advantages and benefits
Allows you to install two sets (doors) on the same rail.
Security: The system is equipped with an anti-derailment device for each bearing support to prevent the door from stalling when misused.
Picture for visual reference only: actual product may vary from that shown in photo.
Be sure to order hardware before beginning fabrication or installation work.
Always use manufacturer-provided instructions as manufacturer reserves the right to make technical changes and modify information without prior notice.
All technical drawings and documents contain examples for the assembly of different supplier hardware. The customer cannot derive any claims from the use of these documents. No responsibility is assumed for design details relating to the construction or project.
Installation should be undertaken by qualified persons.
Never exceed manufacturer-recommended maximum weight or dimensions.
Ensure product is correctly installed using anchors that are appropriate for the supporting material.
Never use spray lubricant on this product.à